Norm

ASTM D2457-13

Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D20.40
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This test method describes procedures for the measurement of gloss of plastic films and solid plastics, both opaque and transparent. It contains four separate gloss angles (Note 1):

1.1.1 60-deg, recommended for intermediate-gloss films,

1.1.2 20-deg, recommended for high-gloss films,

1.1.3 45-deg, recommended for intermediate and low-gloss films,

1.1.4 85-deg, recommended for intermediate and low gloss films, and

1.1.5 75-deg, recommended for plastic siding and soffit.

Note 1The 85-deg, 75-deg, 60-deg, and 20-deg apparatus and method of measurement duplicate those in Test Method D523 and D3679; those for the 45° procedure are similarly taken from Test Method C346.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2There is no known ISO equivalent to this standard.

Details

ICS-code 83.140.10
Nederlandse titel Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics
Engelse titel Standard Test Method for Specular Gloss of Plastic Films and Solid Plastics

Winkelwagen

Subtotaal:

Ga naar winkelwagen