Norm

ASTM D2463 - 10b en

Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers

  • Deze norm is ingetrokken sinds 01-04-2015

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 6
Gepubliceerd op 01-08-2010
Taal Engels

1.1 This test method provides measures of the drop impact resistance of blow-molded thermoplastic containers as a summation of the effects of material, manufacturing conditions, container design, and perhaps other factors.

1.2 Three procedures are provided as follows:

1.2.1 Procedure A, Static Drop Height MethodThis procedure is particularly useful for quality control since it is quick.

1.2.2 Procedure B, Bruceton Staircase MethodThis procedure is used to determine the mean failure height and the standard deviation of the distribution.

1.3 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

Note 1—There is no known ISO equivalent to this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.080.20
Engelse titel Standard Test Method for Drop Impact Resistance of Blow-Molded Thermoplastic Containers
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen