Norm

ASTM D2593-93(2014)

Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D02.D0.04
Gepubliceerd op 01-05-2014
Taal Engels

1.1 This test method covers the determination of butadiene-1,3 purity and impurities such as propane, propylene, isobutane, n-butane, butene-1, isobutylene, propadiene, trans-butene-2, cis -butene-2, butadiene-1,2, pentadiene-1,4, and, methyl, dimethyl, ethyl, and vinyl acetylene in polymerization grade butadiene by gas chromatography. Impurities including butadiene dimer, carbonyls, inhibitor, and residue are measured by appropriate ASTM procedures and the results used to normalize the component distribution obtained by chromatography.

Note 1: Other impurities present in commercial butadiene must be calibrated and analyzed. Other impurities were not tested in the cooperative work on this test method.

Note 2: This test method can be used to check for pentadiene-1,4 and other C5s instead of Test Method D1088.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 6.1 and 9.3.

Details

ICS-code 71.080.10
Nederlandse titel Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography
Engelse titel Standard Test Method for Butadiene Purity and Hydrocarbon Impurities by Gas Chromatography

Winkelwagen

Subtotaal:

Ga naar winkelwagen