Norm

ASTM D2639/D2639M - 19 en

Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer

50,27 60,83 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 6
Gepubliceerd op 01-03-2019
Taal Engels

1.1 This test method covers a relative measure of the plastic behavior of coal when heated under prescribed conditions. This test method may be used to obtain semiquantitative values of the plastic properties of coals and blends used in carbonization and in other situations where determination of plastic behavior of coals is of practical importance.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 75.160.10
Nederlandse titel Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer
Engelse titel Standard Test Method for Plastic Properties of Coal by the Constant-Torque Gieseler Plastometer
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen