ASTM D2671 - 09 en

Standard Test Methods for Heat-Shrinkable Tubing for Electrical Use

  • Deze norm is ingetrokken sinds 01-11-2013

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 19
Gepubliceerd op 01-10-2009
Taal Engels

1.1 These test methods cover the testing of heat-shrinkable tubing used for electrical insulation. Materials used include poly(vinyl chloride), polyolefins, fluorocarbon polymers, silicone rubber, and other plastic or elastomeric compounds.

1.2 The values stated in inch-pound units are to be regarded as standard, except for temperature, which shall be expressed in degrees Celsius. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The procedures appear in the following sections:


ASTM Method
Adhesive Peel Strength98-104
Brittleness Temperature40 D746
Color55 and 56D1535
Color Stability57-62D1535
Copper Stability93
Corrosion Testing89-95
Dielectric Breakdown20-25D149
Dimensions8-13 D876
Fluid Resistance63-67
Fungus Resistance104-108
Heat Resistance49-54
Heat Shock26-30
Low-Temperature Properties36-43
Restricted Shrinkage14-19
Selection of Test Specimens6
Secant Modulus81-84D882
Storage Life31-35
Specific Gravity73 and 74D792
Stress Modulus85-88D412
Tensile Strength and Ultimate Elongation44-48D412
Thermal Endurance96 and 97
Volume Resistivity75-78D257
Water Absorption79 and 80D570
Melting Point104-108D3418

1.4 This is a fire-test-response standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Sections 5 and 68.2.

Note 1—These test methods are similar, but not identical to, those in IEC 606842 (see also Note 9).

68.1 This is a fire-test-response standard. The test procedures measure the resistance of the tubing to ignition and propagation of flame after ignition under prescribed conditions of test.

68.2 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.

68.3 Fire testing is inherently dangerous. Adequate safeguards for personnel and property shall be employed in conducting these tests.


ICS-code 29.035.20
Engelse titel Standard Test Methods for Heat-Shrinkable Tubing for Electrical Use
Vervangen door



Ga naar winkelwagen