ASTM D2710 - 09(2013) en

Standard Test Method for Bromine Index of Petroleum Hydrocarbons by Electrometric Titration

  • Deze norm is ingetrokken sinds 01-12-2018

50,24 54,76 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-10-2013
Taal Engels

1.1 This test method covers the determination of the amount of bromine-reactive material in petroleum hydrocarbons and is thus a measure of trace amounts of unsaturates in these materials. It is applicable to materials having bromine indexes below 1000.

1.2 This test method is applicable only to essentially olefin-free hydrocarbons or mixtures that are substantially free from material lighter than isobutane and have a distillation end point under 288°C (550°F).

Note 1This procedure has been cooperatively tested on materials with bromine indexes in the range from 100 to 1000. These materials include petroleum distillates such as straight-run and hydrocracked naphtha, reformer feed, kerosine, and aviation turbine fuel.
Note 2Materials with bromine index greater than 1000 should be tested for bromine number using Test Method D1159/IP 130.
Note 3Bromine index of industrial aromatic hydrocarbons should be determined using Test Method D1492 or D5776. The subcommittee is currently examining ways to achieve more consistent end point values.

1.3 The values stated in SI units are to be regarded as standard. The values stated in inch-pound units are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 75.100
Engelse titel Standard Test Method for Bromine Index of Petroleum Hydrocarbons by Electrometric Titration
Vervangen door



Ga naar winkelwagen