ASTM D2867-09(2014)

Standard Test Methods for Moisture in Activated Carbon


Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D28.04
Gepubliceerd op 01-07-2014
Taal Engels

1.1 These test methods provide three procedures for the determination of the moisture content of activated carbon. The procedures may also be used to dry samples required for other tests. The oven-drying and moisture balance methods are used when water is the only volatile material present and is in significant quantities, and the activated carbon is not heat-sensitive (some activated carbons can ignite spontaneously at temperatures as low as 150°C). The xylene-extraction method is used when a carbon is known or suspected to be heat sensitive or to contain nonwater-miscible organic compounds instead of or in addition to water. The oven-drying method described in these test methods may be used as the reference for development of instrumental techniques for moisture determination in activated carbon.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 71.040.30
Nederlandse titel Standard Test Methods for Moisture in Activated Carbon
Engelse titel Standard Test Methods for Moisture in Activated Carbon



Ga naar winkelwagen