Norm

ASTM D2939 - 03 en

Standard Test Methods for Emulsified Bitumens Used as Protective Coatings (Withdrawn 2012)

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 7
Gepubliceerd op 10-07-2003
Taal Engels

1.1 These test methods cover procedures for sampling and testing emulsified bitumens used in relatively thick films as protective coatings for metals, built-up roofs, and bituminous pavements.

1.2 The test methods appear in the following order:

Test Procedures for All CoatingsSection
Sampling4
Uniformity5
Resistance to Freezing6
Weight per Gallon7
Residue by Evaporation8
Volatiles9
Ash Content10
Water Content11
Flash Point12
Drying Time13
Resistance to Heat14
Resistance to Water15
Flexibility16
Tests used primarily for coatings used over metals and built-up roofs
Brush-Application Behavior17
Spray-Application Behavior18
Wet Flow19
Direct Flame Test20
Solubility of Residue in Trichloroethylene21
Tests used primarily for coatings used over bituminous pavements
Wet Film Continuity22
Resistance to Volatilization23
Solubility of Residue in Carbon Disulfide24
Resistance to Kerosine25
Resistance to Impact26
Resistance to Impact After Accelerated Weathering27
Aggregate (Sand) Content in Bituminous Emulsions28
Precision Bias29

1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.50
Engelse titel Standard Test Methods for Emulsified Bitumens Used as Protective Coatings (Withdrawn 2012)

Winkelwagen

Subtotaal:

Ga naar winkelwagen