Norm

ASTM D2985/D2985M-92(2011)e1

Standard Test Method for Color of Asbestos

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie C17.03
Gepubliceerd op 01-11-2011
Taal Engels

1.1 This test method covers the determination of color, whiteness, and yellowness of asbestos by means of a photoelectric reflectometer.

1.2 The test method is applicable to all grades and varieties of homogeneous milled asbestos.

1.3 This test method may be applied to samples that are not dry or homogeneous, or that contain impurities or adulterants. However, in such cases, results may not be comparable with those obtained on clean dry samples.

1.4 To obtain similar results from spectrophotometers, see Test Method E308.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 Warning—Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysotile asbestos, refer to Safe Use of Chrysotile: A Manual of Preventive and Control Measures.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ^REFERENCE:

ASTM Standards:

D2244 Practice for Calculation of Color Tolerances and Color Differences from Instrumentally Measured Color Coordinates

D2590 Test Method for Sampling Chrysotile Asbestos

D2946 Terminology for Asbestos and Asbestos–Cement Products

D3879 Test Method for Sampling Amphibole Asbestos (Withdrawn)

E3 Guide for Preparation of Metallographic Specimens

E259 Practice for Preparation of Pressed Powder White Reflectance Factor Transfer Standards for Hemispherical and Bi-Directional Geometries

E308 Practice for Computing the Colors of Objects by Using the CIE System

Details

ICS-code 17.180.20
Nederlandse titel Standard Test Method for Color of Asbestos
Engelse titel Standard Test Method for Color of Asbestos

Winkelwagen

Subtotaal:

Ga naar winkelwagen