Norm

ASTM D3094-00(2010)

Standard Test Method for Seepage Rate of Aerosol Products

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D10.33
Gepubliceerd op 01-10-2010
Taal Engels

1.1 This test method covers the determination of approximate mass loss due to valve seepage rate of aerosol products by the collection and measurement of gases seeping through the valve and into a special eudiometer tube, over a relatively short time period.

1.2 It can be shown that the average refrigeration-filled aerosol product seeps to the extent of approximately 3.0 mL when the corresponding mass loss is 0.10 oz (2.9 cm3)/year. This figure is partially based on air content and is subject to variations according to filling conditions. This test method is not considered dependable when applied to pressure-filled, unpurged aerosol products.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 55.130
Nederlandse titel Standard Test Method for Seepage Rate of Aerosol Products
Engelse titel Standard Test Method for Seepage Rate of Aerosol Products

Winkelwagen

Subtotaal:

Ga naar winkelwagen