Norm

ASTM D3123-09

Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.30
Gepubliceerd op 01-09-2009
Taal Engels

1.1 This test method covers a procedure for measuring the spiral flow of thermosetting molding compounds (soft or very soft) designed for molding pressures under 6.9 MPa (1000 psi). It is especially suited for those compounds used for encapsulation or other low pressure molding techniques. It involves the use of a standard spiral flow mold in a transfer molding press under specified conditions of applied temperature and pressure with a controlled charge mass.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this test method.

Details

ICS-code 83.140.99
Nederlandse titel Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds
Engelse titel Standard Test Method for Spiral Flow of Low-Pressure Thermosetting Molding Compounds

Winkelwagen

Subtotaal:

Ga naar winkelwagen