Norm

ASTM D3139-98(2011)

Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie F17.20
Gepubliceerd op 01-02-2011
Taal Engels

1.1 This specification covers the types of joints required for plastic pipe pressure systems with a wall thickness equal to or greater than that of SDR 64 and intended for use in supply and distribution lines for water, using flexible elastomeric seals. This specification covers the test requirements, test method, and materials. The test methods described are not intended to be routine quality control tests, but are to evaluate the performance characteristics of the joint.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The following safety hazards caveat pertains to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.20
Nederlandse titel Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
Engelse titel Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals

Winkelwagen

Subtotaal:

Ga naar winkelwagen