Norm

ASTM D3142/D3142M-11

Standard Test Method for Specific Gravity, API Gravity, or Density of Cutback Asphalts by Hydrometer Method

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D04.47
Gepubliceerd op 15-12-2011
Taal Engels

1.1 This test method covers the laboratory determination, using a glass hydrometer, of the density, specific gravity, or API gravity of cutback asphalts as defined in Specifications D2026, D2027, and D2028 (Note 1). Values are measured on a hydrometer at convenient temperatures, readings of density, specific gravity, and API gravity being reduced to 15°C or 60°F by means of international standard tables. By means of these same tables, values determined in one of the three systems of measurement are convertible to equivalent values in either system so that measurements may be made in the units of local convenience.

Note 1—This test method is applicable to cutback asphalts and in general follows, but provides more explicit routines than, the procedure outlined in Test Method D1298.

1.2 UnitsThe values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

Details

ICS-code 91.100.50
93.080.20
Nederlandse titel Standard Test Method for Specific Gravity, API Gravity, or Density of Cutback Asphalts by Hydrometer Method
Engelse titel Standard Test Method for Specific Gravity, API Gravity, or Density of Cutback Asphalts by Hydrometer Method

Winkelwagen

Subtotaal:

Ga naar winkelwagen