Norm

ASTM D3153-87(2015)

Standard Test Method for Recoatability of Water-Emulsion Floor Polishes

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D21.04
Gepubliceerd op 01-11-2015
Taal Engels

1.1 This test method covers the determination of the effects of the application of a water-emulsion floor polish over a dried coating of the same polish. The method is designed for laboratory bench panel testing. A method is also provided for large area testing. A rating system is provided to indicate the acceptability of the polish based on recoatability performance.

Note 1: Recoatability of a water-emulsion floor polish is a general-performance property, and the determination of it is dependent upon the observation of several other properties of the polish under the specific conditions expressed in this test method. This test method for recoatability is not designed for the evaluation of other properties, except as these properties relate to the recoatability of the specific polish being evaluated under the conditions of this test.

1.2 Gloss as observed herein extends only to freedom from loss of apparent visual gloss upon recoating, in the execution of this test method, and should this loss occur, it indicates a distortion of the property of gloss, by recoating.

1.3 A degree of recoatability failure may be reflected from a degree of leveling failure. The failure to level should be observed only if it is to be a part of the observation of recoatability.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 71.100.99
97.080
Nederlandse titel Standard Test Method for Recoatability of Water-Emulsion Floor Polishes
Engelse titel Standard Test Method for Recoatability of Water-Emulsion Floor Polishes

Winkelwagen

Subtotaal:

Ga naar winkelwagen