Norm

ASTM D3154-14

Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)

61,51

Over deze norm

Status Definitief
Aantal pagina's 12
Commissie D22.03
Gepubliceerd op 01-04-2014
Taal Engels

1.1 This test method describes measurement of the average velocity of a gas stream for the purpose of determining gas flow in a stack, duct, or flue. Although technically complex, it is generally considered the most accurate and often the only practical test method for taking velocity measurements.

1.2 This test method is suitable for measuring gas velocities above 3 m/s (10 ft/s).

1.3 This test method provides procedures for determining stack gas composition and moisture content.

1.4 The values stated in SI units are to be regarded as standard. The inch-pound units given in parentheses are for information only.

1.5 This test method is applicable to conditions where steady-state flow occurs, and for constant fluid conditions, where the direction of flow is normal to the face tube opening of the pitot tube employed in the method. The method cannot be used for direct measurement when cyclonic or swirling flow conditions are present.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.120.20
Nederlandse titel Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)
Engelse titel Standard Test Method for Average Velocity in a Duct (Pitot Tube Method)

Winkelwagen

Subtotaal:

Ga naar winkelwagen