Norm

ASTM D3159 - 10 en

Standard Specification for Modified ETFE-Fluoropolymer Molding and Extrusion Materials

  • Deze norm is ingetrokken sinds 01-09-2015

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-11-2010
Taal Engels

1.1 This specification covers melt processible molding and extrusion materials of modified ETFE-fluoropolymer. The ETFE resin is a copolymer of ethylene containing approximately 75 mass % of tetrafluoroethylene.

1.2 The values stated in SI units as detailed in are to be regarded as standard. The values given in parentheses are for information only.

Note 1—Although this specification and ISO 12086-1 (1994) and ISO 12086-2 (1994) differ in approach or detail, data obtained using either are technically equivalent.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 Recycled material is not appropriate for this specification because performance requirements cannot be met with recycled material. Therefore, this specification is for virgin material only.

Details

ICS-code 83.080.20
Engelse titel Standard Specification for Modified ETFE-Fluoropolymer Molding and Extrusion Materials
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen