Norm

ASTM D3159-15

Standard Specification for Modified ETFE Fluoropolymer Molding and Extrusion Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D20.15
Gepubliceerd op 01-09-2015
Taal Engels

1.1 This specification covers molding and extrusion materials of modified ETFE fluoropolymer. The ETFE resin is a copolymer of ethylene and tetrafluoroethylene. Modified ETFE resin contains no more than 5 mole % of other fluoromonomers.

1.2 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as standard. The values given in parentheses are for information only.

Note 1: Although this specification and ISO 12086-1 and ISO 12086-2 differ in approach or detail, data obtained using either are technically equivalent.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 Recycled material is not appropriate for this specification because performance requirements cannot be met with recycled material. Therefore, this specification is for virgin material only.

Details

ICS-code 83.080.20
Nederlandse titel Standard Specification for Modified ETFE Fluoropolymer Molding and Extrusion Materials
Engelse titel Standard Specification for Modified ETFE Fluoropolymer Molding and Extrusion Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen