ASTM D3218-07(2012)

Standard Specification for Polyolefin Monofilaments


Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D13.58
Gepubliceerd op 01-07-2012
Taal Engels

1.1 This specification covers polyolefin monofilament yarn materials, and test methods for standard polyolefin monofilaments. While designed primarily for testing standard polyolefin monofilaments, many of the procedures can be used, with little or no modification, for other polyolefin monofilaments. However, testing on non-standard polyolefin monofilaments should be conducted with caution. See 3.1 for a definition of standard polyolefin monofilament.

1.2 Only on condition that interlaboratory precision data are available for the specific procedure is any test method described, or referenced in this specification, recommended for acceptance testing of commercial shipments of polyolefin monofilaments.

1.3 The specification for polyolefin raw materials appears in Section 4.

1.4 The test methods for individual properties appear in the following sections:

Breaking Force10
Breaking Tenacity10
Hot Water Shrinkage14
Initial Modulus10
Polyolefin-Material Cleanliness17
Resistance to Ultraviolet Radiation15
Stability to Thermal Oxidation16
Tensile Properties10
Thickness 12
Yarn Number9

Note 1—In most instances, the suitability of these procedures for polymeric yarns in general, and polyolefin monofilaments in particular, is already accepted in commercial transactions (see 6.1).

1.5 The values stated in SI units are to be regarded as standard; the values in English units are provided as information only and are not exact equivalents.

1.6 The following safety hazards caveat pertains only to the test methods described in this specification: This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 59.060.20
Nederlandse titel Standard Specification for Polyolefin Monofilaments
Engelse titel Standard Specification for Polyolefin Monofilaments



Ga naar winkelwagen