Norm

ASTM D3275-08(2013)

Standard Classification System for E-CTFE-Fluoroplastic Molding, Extrusion, and Coating Materials

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.15
Gepubliceerd op 01-05-2013
Taal Engels

1.1 This classification system covers melt processible molding, extrusion, and coating materials of ethylene-chlorotrifluoroethylene (E-CTFE) fluoroplastics. The resin is a copolymer of ethylene and chlorotrifluoroethylene containing approximately 80 weight % of chlorotrifluoroethylene.

1.2 The values stated in SI units, as detailed in IEEE/ASTM SI-10, are to be regarded as standard.

1.3 The following precautionary statement pertains only to the test methods portion, Section 11 of this classification system.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1Although this classification system and ISO 12086-1 and ISO 12086-2 differ in approach or detail, data obtained using either are technically equivalent.

Details

ICS-code 83.080.20
Nederlandse titel Standard Classification System for E-CTFE-Fluoroplastic Molding, Extrusion, and Coating Materials
Engelse titel Standard Classification System for E-CTFE-Fluoroplastic Molding, Extrusion, and Coating Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen