Norm

ASTM D3288/D3288M - 20 en

Standard Test Methods for Magnet-Wire Enamels

57,09 62,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 7
Gepubliceerd op 01-08-2020
Taal Engels

1.1 These test methods cover testing liquid enamel coatings used to produce film-insulated magnet wire.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined

1.3 The test methods appear as follows:

 

Sections

Density

6 – 10

Determined Solids

16 – 22

Effective Solids

31 – 37

Flash Point

11 – 15

Infrared Analysis

45 – 50

Stack Loss

23 – 30

Viscosity

38 – 44

1.4 There is no known IEC equivalent document.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 25.220.50
Engelse titel Standard Test Methods for Magnet-Wire Enamels
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen