Norm

ASTM D3307-16

Standard Specification for Perfluoroalkoxy (PFA) Resin Molding and Extrusion Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D20.15
Gepubliceerd op 01-04-2016
Taal Engels

1.1 This specification covers melt processable molding and extrusion materials of Perfluoroalkoxy (PFA) resin. The materials are copolymers of tetrafluoroethylene and perfluoroalkoxy.

1.2 This specification is intended to provide a means for calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection should be made by those having expertise in the plastics field after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those covered by this specification.

1.3 This specification does not cover recycled plastics.

1.4 The values stated in SI units2 are to be regarded as standard. The values given in parentheses are for information only.

1.5 The following precautionary caveat pertains only to the test methods portions, Sections 8 and 9 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: This specification, ISO 12086–1(2006), and ISO 12086–2(2006) differ in approach or detail. Data obtained using either may not be technically equivalent.

Details

ICS-code 83.140.99
Nederlandse titel Standard Specification for Perfluoroalkoxy (PFA) Resin Molding and Extrusion Materials
Engelse titel Standard Specification for Perfluoroalkoxy (PFA) Resin Molding and Extrusion Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen