Norm

ASTM D3354-15

Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.19
Gepubliceerd op 01-04-2015
Taal Engels

1.1 This test method yields quantitative information regarding the degree of blocking (unwanted adhesion) existing between layers of plastic film. It is not intended to measure susceptibility to blocking.

1.2 By this procedure, the film-to-film adhesion, expressed as a blocking load in grams, will cause two layers of film with an area of contact of 100 cm2 to separate. The test method is limited to a maximum load of 200 g.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: This test method is similar to ISO 11502 Method B, but is not technically equivalent.

Details

ICS-code 83.140.10
Nederlandse titel Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method
Engelse titel Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method

Winkelwagen

Subtotaal:

Ga naar winkelwagen