Norm

ASTM D3419-12

Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.09
Gepubliceerd op 01-04-2012
Taal Engels

1.1 This practice covers the general principles to be followed when injection molding test specimens of thermosetting materials. It is to be used to obtain uniformity in methods of describing the various steps of the injection molding process and in the reporting of those conditions. The exact molding conditions will vary from material to material, and if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used and its plasticity.

Note 1—The utility of this practice has been demonstrated for the molding of thermosetting molding compounds exhibiting lower-viscosity non-Newtonian flow.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This practice assumes the use of reciprocating screw injection molding machines.

Note 2—This standard and ISO 10724 address the same subject matter, but differ in technical content.

Details

ICS-code 83.140.99
Nederlandse titel Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds
Engelse titel Standard Practice for In-Line Screw-Injection Molding Test Specimens From Thermosetting Compounds

Winkelwagen

Subtotaal:

Ga naar winkelwagen