ASTM D3441-16

Standard Test Method for Mechanical Cone Penetration Testing of Soils


Over deze norm

Status Definitief
Aantal pagina's 8
Commissie D18.02
Gepubliceerd op 01-07-2016
Taal Engels

1.1 This test method covers the procedure for determining the point resistance during penetration of a conical-shaped penetrometer as it is advanced into subsurface soils at a steady rate.

1.2 This test method may also used to determine the frictional resistance of a cylindrical sleeve located behind the conical point as it is advanced through subsurface soils at a steady rate.

1.3 This test method applies to mechanical-type penetrometers. Field tests using penetrometers of electronic type are covered elsewhere by Test Method D5778.

1.4 Cone penetration test data can be used to interpret subsurface stratigraphy, and through use of site specific correlations, they can provide data on engineering properties of soils intended for use in design and construction of earthworks and foundations for structures.

1.5 Mechanical penetrometers of the type described in this test method operate either continually (in which cone penetration resistance is measured while cone and push rods are moving continuously until stopped for the addition of a push rod) or discontinuously (in which cone penetration resistance and, optionally, sleeve friction are measured during a penetration stop of the push rods) using an inner rod system and a penetrometer tip (that must be telescoping in case of discontinuous operation).

1.6 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered as requirements of the standard. The illustrations included in this standard are intended only for explanatory or advisory use.

1.7 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Reporting of test results in units other than SI shall not be regarded as nonconformance with this test method.

1.8 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D6026 unless superseded by this standard.

1.8.1 The procedures used to specify how data are collected/recorded and calculated in this standard are regarded as the industry standard. In addition, they are representative of the significant digits that should generally be retained. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to commensurate with these considerations. It is beyond the scope of this standard to consider significant digits used in analysis methods for engineering design.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Nederlandse titel Standard Test Method for Mechanical Cone Penetration Testing of Soils
Engelse titel Standard Test Method for Mechanical Cone Penetration Testing of Soils



Ga naar winkelwagen