Norm

ASTM D3448-10(2015)e1

Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D26.04
Gepubliceerd op 01-06-2015
Taal Engels

1.1 This test method covers the determination of aqueous conductivity due to ionizable contaminants extracted from trichlorotrifluoroethane. The value of 1.9 μS/cm as maximum specific aqueous conductance corresponds to 0.1 ppm of chloride ion (100 ppb). It was calculated by putting the solvent specification of 0.1 ppm chloride into the equation of the subject method to find C2 − C1 equals 19.08. The specific conductance due to contaminants from the solvent was then calculated as follows:

Equation D3448-10R15E01_1

1.2 The above is exclusive of the background specific conductance of the water used in the analysis.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3.1 Exception—Values are stated in inch-pound units in Fig. 1.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 6.

Details

ICS-code 71.080.20
Nederlandse titel Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane
Engelse titel Standard Test Method for Specific Aqueous Conductance of Trichlorotrifluoroethane

Winkelwagen

Subtotaal:

Ga naar winkelwagen