Norm

ASTM D349-13

Standard Test Methods for Laminated Round Rods Used for Electrical Insulation

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D09.07
Gepubliceerd op 01-11-2013
Taal Engels

1.1 These test methods cover the procedures for testing rigid round rods used in electrical insulation. These round rods include many types made from fibrous sheets of basic materials, such as cellulose, glass, or nylon in the form of paper, woven fabrics, or mats, bonded together by natural or synthetic resins, or by adhesives. Such round rods include vulcanized fiber and thermosetting laminates as well as round rods made from cast, molded, or extruded natural or synthetic resins, with or without fillers or reinforcing materials.

1.2 The procedures appear in the following sections:

 

Section

Compressive strength (axial)

20 – 25

Density

28 – 30

Dielectric strength

31 – 39

Flexural strength

13 – 19

Tensile strength

 7 – 12

Water absorption

26-27


1.3 The values stated in inch-pound units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific warning statement see 36.2.

Details

ICS-code 29.035.99
Nederlandse titel Standard Test Methods for Laminated Round Rods Used for Electrical Insulation
Engelse titel Standard Test Methods for Laminated Round Rods Used for Electrical Insulation

Winkelwagen

Subtotaal:

Ga naar winkelwagen