Norm

ASTM D3588-98(2017)

Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

51,52

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D03.03
Gepubliceerd op 01-04-2017
Taal Engels

1.1 This practice covers procedures for calculating heating value, relative density, and compressibility factor at base conditions (14.696 psia and 60°F (15.6°C)) for natural gas mixtures from compositional analysis.2 It applies to all common types of utility gaseous fuels, for example, dry natural gas, reformed gas, oil gas (both high and low Btu), propane-air, carbureted water gas, coke oven gas, and retort coal gas, for which suitable methods of analysis as described in Section 6 are available. Calculation procedures for other base conditions are given.

1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 75.160.30
Nederlandse titel Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels
Engelse titel Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels

Winkelwagen

Subtotaal:

Ga naar winkelwagen