Norm

ASTM D3633/D3633M-12

Standard Test Method for Electrical Resistivity of Membrane-Pavement Systems

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D04.32
Gepubliceerd op 01-06-2012
Taal Engels

1.1 This test method covers the measurement of the electrical resistivity of water-barrier membrane-pavement systems when applied to concrete bridge decks.

1.2 Measurements shall be performed on the bituminous pavement surface covering the water-barrier membrane.

1.3 This test method utilizes a measure of electrical resistance between the saturated top surface of the water-barrier membrane and the reinforcing steel embedded in the concrete bridge deck.

1.4 The values measured represent the electrical resistance obtained with the equipment and procedures stated herein and do not necessarily agree or correlate with those using other equipment or procedures.

1.5 UnitsThe values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 93.080.20
Nederlandse titel Standard Test Method for Electrical Resistivity of Membrane-Pavement Systems
Engelse titel Standard Test Method for Electrical Resistivity of Membrane-Pavement Systems

Winkelwagen

Subtotaal:

Ga naar winkelwagen