Norm

ASTM D3667-16

Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D11.37
Gepubliceerd op 01-07-2016
Taal Engels

1.1 This specification covers the general requirements for materials used in rubber seals of flat-plate solar collectors, except vertically mounted passive collectors. Particular applications may necessitate other requirements that would take precedence over these requirements when specified.

1.2 The design requirement pertains only to permissible deflections of the rubber during thermal expansion or contraction of the seal in use and the tolerances in dimensions of molded and extruded seals.

1.3 This specification does not include requirements pertaining to the fabrication or installation of the seals.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 The following safety hazards caveat pertains only to Section 9, Test Methods, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.140
Nederlandse titel Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors
Engelse titel Standard Specification for Rubber Seals Used in Flat-Plate Solar Collectors

Winkelwagen

Subtotaal:

Ga naar winkelwagen