Norm

ASTM D3763 - 10e1 en

Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors

  • Deze norm is ingetrokken sinds 01-12-2014

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Gepubliceerd op 01-07-2010
Taal Engels

1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.

1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This specification does not closely conform to ISO 6603.2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, and specimen geometries and in test velocity can produce significantly different test results.

Details

ICS-code 83.080.01
Engelse titel Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen