Over deze norm
1.1 This test method covers the determination of puncture properties of rigid plastics over a range of test velocities.
1.2 Test data obtained by this test method are relevant and appropriate for use in engineering design.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 1: This standard and ISO 6603.2 address the same subject matter, but differ in technical content. The technical content and results shall not be compared between the two test methods.
|Engelse titel||Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors|