ASTM D3767-03(2014)

Standard Practice for Rubber—Measurement of Dimensions


Over deze norm

Status Definitief
Aantal pagina's 8
Commissie D11.10
Gepubliceerd op 01-11-2014
Taal Engels

1.1 This practice is intended for use in determining the geometrical dimensions of rubber products and specimens for physical tests. This practice describes procedures for determining length, width, thickness, diameter, and circumference. This practice does not cover sampling of materials or products, or locations where a sample is to be taken.

1.2 The values stated in either acceptable metric units or in other units shall be regarded separately as a standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any other way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.


ICS-code 83.060
Nederlandse titel Standard Practice for Rubber—Measurement of Dimensions
Engelse titel Standard Practice for Rubber—Measurement of Dimensions



Ga naar winkelwagen