Norm

ASTM D3885-07a(2015)

Standard Test Method for Abrasion Resistance of Textile Fabrics (Flexing and Abrasion Method)

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D13.60
Gepubliceerd op 01-07-2015
Taal Engels

1.1 This test method2 covers the determination of the abrasion resistance of woven or nonwoven textile fabrics using the flexing and abrasion tester.

1.2 This test method applies to most woven and nonwoven fabrics providing they do not stretch excessively. It is not applicable to floor coverings.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as the standard. Within the text, the inch-pound units are shown in parentheses. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: For other test methods for abrasion resistance of textiles refer to Test Methods D3884, D3886, D4157, D4158, D4966, and AATCC93.

Details

ICS-code 59.080.30
Nederlandse titel Standard Test Method for Abrasion Resistance of Textile Fabrics (Flexing and Abrasion Method)
Engelse titel Standard Test Method for Abrasion Resistance of Textile Fabrics (Flexing and Abrasion Method)

Winkelwagen

Subtotaal:

Ga naar winkelwagen