Norm

ASTM D3912-10

Standard Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie D33.02
Gepubliceerd op 15-05-2010
Taal Engels

1.1 This test method establishes procedures for the evaluation of the chemical resistance of coatings and linings for use in Coating Service Level I and II applications in nuclear power plants.

1.2 This test method is intended to be used as a screening test to evaluate coatings and linings on steel and concrete substrates.

1.3 This test method addresses two exposure intervals:

(1) Short Term (Typically 5 days): Such exposures are primarily applicable for coatings exposed to chemical splash or spill.

(2) Long Term (Typically 180 days): Such exposures are primarily applicable for linings exposed to continuous or near-continuous chemical immersion.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 87.040
Nederlandse titel Standard Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants
Engelse titel Standard Test Method for Chemical Resistance of Coatings and Linings for Use in Nuclear Power Plants

Winkelwagen

Subtotaal:

Ga naar winkelwagen