Over deze norm
1.1 This test method describes a procedure for determining the tensile properties of pultruded, glass-fiber-reinforced thermosetting plastic rod of diameters ranging from 3.2 mm (1/8 in.) to 25.4 mm (1 in.). Little test specimen preparation is required; however, reusable aluminum tab grip adapters ( ) of appropriate size are required to prevent premature failure of the specimens at the grips.
Note 1: Sandblast Clamp Face with 100-mesh Carbide at 100 psi.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in and .
Note 1: There is no known ISO equivalent to this standard.
|Nederlandse titel||Standard Test Method for Tensile Properties of Pultruded Glass-Fiber-Reinforced
|Engelse titel||Standard Test Method for Tensile Properties of Pultruded Glass-Fiber-Reinforced