Norm

ASTM D3928-00a(2014)

Standard Test Method for Evaluation of Gloss or Sheen Uniformity

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D01.42
Gepubliceerd op 01-12-2014
Taal Engels

1.1 This test method covers the determination of the uniformity of gloss or sheen of a paint applied by brush to a test panel simulating an interior wall section. Variations in gloss or sheen that may be caused by short wet edge time, poor leveling, and pigment orientation or flotation during and after application are evaluated visually.

1.2 Because both the application and the panel evaluation are very subjective, this test method should be used only for comparative testing within one laboratory as the ratings assigned by different laboratories do not usually agree (see 8.1).

1.3 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 87.040
Nederlandse titel Standard Test Method for Evaluation of Gloss or Sheen Uniformity
Engelse titel Standard Test Method for Evaluation of Gloss or Sheen Uniformity

Winkelwagen

Subtotaal:

Ga naar winkelwagen