Norm

ASTM D3935-15

Standard Classification System and Basis for Specification for Polycarbonate (PC) Unfilled and Reinforced Material

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D20.15
Gepubliceerd op 15-05-2015
Taal Engels

1.1 This classification system covers unfilled and reinforced polycarbonate and polycarbonate copolymer materials suitable for injection molding, blow molding, and extrusion. Some of these compositions may also find use for compression molding or application from solution. This classification system allows for the use of recycled materials provided that all specification requirements are met.

1.2 The properties in this classification system are those required for identifying the compositions covered. Other requirements necessary for identifying particular characteristics important to specific applications are normally specified by using the suffixes in accordance with Section 5.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This classification system and subsequent line callout (specification) are intended to provide a means of calling out plastic materials used in the fabrication of end items or parts. It is not intended for the selection of materials. Material selection should be made by those having expertise in the plastic field only after consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, the costs involved, and the inherent properties of the material other than those covered in this standard.

Note 1: This classification system and ISO 7391-1 and ISO 7391-2 address the same subject matter, but differ in technical content.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 12, of this classification system. This standard does not purport to address all safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability or regulatory limitations prior to use.

Details

ICS-code 83.080.20
83.120
Nederlandse titel Standard Classification System and Basis for Specification for Polycarbonate (PC) Unfilled and Reinforced Material
Engelse titel Standard Classification System and Basis for Specification for Polycarbonate (PC) Unfilled and Reinforced Material

Winkelwagen

Subtotaal:

Ga naar winkelwagen