Norm

ASTM D4026-06(2012)

Standard Test Method for Rubber Latex—Styrene-Butadiene Copolymer—Determination of Residual Styrene

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D11.11
Gepubliceerd op 01-05-2012
Taal Engels

1.1 This test method covers the determination of the residual styrene content of styrene butadiene (SBR) latex. This test method is based upon direct injection of a diluted latex into a gas chromatograph. The amount of residual styrene is calculated using an internal standard technique.

1.2 The range of residual styrene covered is approximately 100 to 3000 mg/kg (ppm) with a lower detection limit of approximately 50 mg/kg (ppm).

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific safety statements, see Section 8.)

Details

ICS-code 83.040.10
83.060
Nederlandse titel Standard Test Method for Rubber Latex—Styrene-Butadiene Copolymer—Determination of Residual Styrene
Engelse titel Standard Test Method for Rubber Latex—Styrene-Butadiene Copolymer—Determination of Residual Styrene

Winkelwagen

Subtotaal:

Ga naar winkelwagen