Norm

ASTM D413-98(2013)

Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D11.25
Gepubliceerd op 01-11-2013
Taal Engels

1.1 These test methods cover the determination of the adhesion strength between plies of fabric bonded with rubber or the adhesion of the rubber layer in articles made from rubber attached to other material. They are applicable only when the adhered surfaces are approximately plane or uniformly circular as in belting, hose, tire carcasses, or rubber-covered sheet metal.

1.2 When the adhered surfaces contain sharp bends, angles, or other gross irregularities that cannot be avoided in preparing test specimens, special test methods must be employed for evaluating adhesion.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.060
Nederlandse titel Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate
Engelse titel Standard Test Methods for Rubber Property—Adhesion to Flexible Substrate

Winkelwagen

Subtotaal:

Ga naar winkelwagen