Norm

ASTM D4242-07(2013)

Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D01.51
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method specifies a method for determining the flow characteristics of a fused thermosetting coating powder down a plane inclined at a set angle to the horizontal. The test gives an indication of the degree of melt flow that may occur during the curing of the coating powder. This characteristic contributes to the coherence of the coating, to its surface appearance and to the degree of coverage over sharp edges (see Test Method D2967), however, it should not be used as the sole factor for judgment. The test acts as a useful method for checking for batch to batch variation in the behavior of a given coating powder. Correlation between the results from coating powders of differing composition is not to be expected. This method is unlikely to yield meaningful results with coating powders which have gel times of less than one minute at the test temperature (see Test Method D4217). Oven drafts, angle of inclination and pellet variations significantly affect results making inter-lab reproducibility somewhat difficult to correlate.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.080.10
Nederlandse titel Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders
Engelse titel Standard Test Method for Inclined Plate Flow for Thermosetting Coating Powders

Winkelwagen

Subtotaal:

Ga naar winkelwagen