Norm

ASTM D4261 - 05(2018) en

Standard Practice for Surface Cleaning Concrete Masonry Units for Coating

44,68 54,06 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 2
Gepubliceerd op 01-08-2018
Taal Engels

1.1 This practice covers surface cleaning of concrete masonry units to remove dust, dirt, mortar spatter, oil, and grease prior to the application of coatings. Procedures include vacuum cleaning, air-blast cleaning, water cleaning, detergent water wash, steam cleaning, and mechanical cleaning.

1.2 This practice may alter the surface profile of the concrete but is primarily intended to clean the surface.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 91.080.40
Nederlandse titel Standard Practice for Surface Cleaning Concrete Masonry Units for Coating
Engelse titel Standard Practice for Surface Cleaning Concrete Masonry Units for Coating
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen