Norm

ASTM D4325-13

Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D09.07
Gepubliceerd op 01-11-2013
Taal Engels

1.1 These test methods cover the methods and procedures for testing electrically insulating and semi-nonmetallic conducting rubber tapes designed for splicing, terminating, and sheath repair of electrical wire and cable.

1.2 The test methods appear in the following sections:

 

Section

Referenced Documents

2

Conditioning

5-6

Dielectric Strength

35 – 40

Dimensions

11 – 16

Dissipation Factor

22 – 26

Elongation

17 – 21

Heat Exposure

46 – 49

Fusion

7 – 10

Ozone Resistance

41 – 45

Permittivity

22 – 26

Sample Requirements

4

Tensile Strength

17 – 21

Volume Resistivity

27 – 34

Ultraviolet and Weather Resistance

50 – 54


1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

Note 1There is no IEC equivalent to these methods.

1.4 Unless otherwise stated, measurements are made on tapes from which the removable separator has been removed.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precaution statements see 43.1.

1.6 This is a fire-test response standard.

Details

ICS-code 29.035.20
Nederlandse titel Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes
Engelse titel Standard Test Methods for Nonmetallic Semi-Conducting and Electrically Insulating Rubber Tapes

Winkelwagen

Subtotaal:

Ga naar winkelwagen