Norm

ASTM D4382-12

Standard Test Method for Barium in Water, Atomic Absorption Spectrophotometry, Graphite Furnace

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D19.05
Gepubliceerd op 01-09-2012
Taal Engels

1.1 This test method covers the determination of dissolved and total recoverable barium in most waters and wastewaters.

1.2 This test method was evaluated in the range from 33.5 to 132 μg/L of barium. The range can be increased or decreased by varying the volume of sample injected or the instrumental settings. High concentrations may be diluted but preferably should be analyzed by direct aspiration atomic absorption spectrophotometry.

1.3 This test method has been used successfully with waste treatment plant effluent water, lake water, filtered tap water, and well water. It is the responsibility of the analyst to determine the suitability of the test method for other matrices.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 13.060.50
Nederlandse titel Standard Test Method for Barium in Water, Atomic Absorption Spectrophotometry, Graphite Furnace
Engelse titel Standard Test Method for Barium in Water, Atomic Absorption Spectrophotometry, Graphite Furnace

Winkelwagen

Subtotaal:

Ga naar winkelwagen