Norm

ASTM D4444-13

Standard Test Method for Laboratory Standardization and Calibration of Hand-Held Moisture Meters

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie D07.01
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This test method applies to the measurement of moisture content (MC) of solid wood products, including those containing additives (that is, chemicals or adhesives) for laboratory standardization and calibration of hand-held moisture meters

1.2 This test method makes no distinction between meter measurement technologies for standardization and calibration requirements. Provision is made for test specimen size to accommodate specific meters. Appendix X1 provides an explanatory discussion and history corresponding to the mandatory sections. Fundamental measurement technologies are described in Appendix X2 when available.

1.2.1 Meters employing differing technologies may not provide equivalent readings under the same conditions. When this test method has been applied, it is assumed that the referenced meter is acceptable unless otherwise specified. Meters shall be calibrated with respect to MC by direct measurement as determined by Test Methods D4442.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 07.060
Nederlandse titel Standard Test Method for Laboratory Standardization and Calibration of Hand-Held Moisture Meters
Engelse titel Standard Test Method for Laboratory Standardization and Calibration of Hand-Held Moisture Meters

Winkelwagen

Subtotaal:

Ga naar winkelwagen