Norm

ASTM D4476/D4476M-14-14

Standard Test Method for Flexural Properties of Fiber Reinforced Pultruded Plastic Rods

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D20.18
Gepubliceerd op 01-05-2014
Taal Engels

1.1 This test method covers the determination of the flexural properties of fiber-reinforced pultruded plastic rods. The specimen is a rod with a semicircular cross section, molded or cut from lengths of pultruded rods (see Fig. 1). This test method is designed for rods with a diameter of 1/2 in. or greater.

Note 1There is no known ISO equivalent to this standard.
 Cross Section of Test Specimen
FIG. 1 Cross Section of Test Specimen

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.120
Nederlandse titel Standard Test Method for Flexural Properties of Fiber Reinforced Pultruded Plastic Rods
Engelse titel Standard Test Method for Flexural Properties of Fiber Reinforced Pultruded Plastic Rods

Winkelwagen

Subtotaal:

Ga naar winkelwagen