Norm

ASTM D4482-11

Test Method for Rubber PropertyExtension Cycling Fatigue

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie D11.15
Gepubliceerd op 01-05-2011
Taal Engels

1.1 This test method covers the determination of fatigue life of rubber compounds undergoing a tensile-strain cycle. During part of the cycle, the strain is relaxed to a zero value. The specimens are tested without intentionally initiated flaws, cuts, or cracks. Failure is indicated by a complete rupture of the test specimen.

1.2 No exact correlation between these test results and service is given or implied. This is due to the varied nature of service conditions. These test procedures do yield data that can be used for the comparative evaluation of rubber compounds for their ability to resist (dynamic) extension cycling fatigue.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.060
Nederlandse titel Test Method for Rubber PropertyExtension Cycling Fatigue
Engelse titel Test Method for Rubber PropertyExtension Cycling Fatigue

Winkelwagen

Subtotaal:

Ga naar winkelwagen