Norm

ASTM D4585/D4585M-13

Standard Practice for Testing Water Resistance of Coatings Using Controlled Condensation

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D01.27
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This practice covers basic principles and operating procedures for testing water resistance of coatings using controlled condensation. Condensation is produced by exposing one surface of a coated specimen to a heated, saturated mixture of air and water vapor, while the reverse side of the specimen is exposed to the cooling effect of room temperature air. This practice is derived from research of the Cleveland Society for Coatings Technology.2

1.2 This practice is limited to the methods of obtaining, measuring, and controlling conditions and procedures of controlled condensation tests. It does not specify specimen preparation, specific test conditions, or evaluation of results.

Note 1Alternative practices for testing water resistance of coatings include Practices D870, D1735, and D2247.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 87.040
Nederlandse titel Standard Practice for Testing Water Resistance of Coatings Using Controlled Condensation
Engelse titel Standard Practice for Testing Water Resistance of Coatings Using Controlled Condensation

Winkelwagen

Subtotaal:

Ga naar winkelwagen