Norm

ASTM D4620-02(2012)

Standard Test Method for Evaluating the Effective Surface Area of Zinc Oxide in Rubber

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie D11.20
Gepubliceerd op 01-05-2012
Taal Engels

1.1 This test method specifies the standard materials, mixing procedure, and test method for ranking zinc-oxide samples according to their specific surface area in a standard test formula based on chloroprene rubber (CR).

1.2 The ranking is based on the cure time of the standard CR formulation.

1.3 The accurate surface area cannot be determined by this test method, since factors other than surface area may influence the cure times to some extent (for example acidity, heavy metal traces, etc.).

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.060
Nederlandse titel Standard Test Method for Evaluating the Effective Surface Area of Zinc Oxide in Rubber
Engelse titel Standard Test Method for Evaluating the Effective Surface Area of Zinc Oxide in Rubber

Winkelwagen

Subtotaal:

Ga naar winkelwagen