Norm

ASTM D4713-12

Standard Test Methods for Nonvolatile Content of Heatset and Liquid Printing Ink Systems

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D01.56
Gepubliceerd op 01-11-2012
Taal Engels

1.1 These test methods cover the determination of weight content of nonvolatile matter in two types of printing inks.

1.2 Test Method A is applicable to heatset-type printing inks and resin solutions; solvents in such systems typically have initial boiling points in the range from 240 to 275??C (470 to 535??F) and vapor pressures less than 0.2 mm Hg.

1.3 Test Method B is applicable to liquid-type printing inks and vehicles based on aqueous or organic solvents that evaporate readily at ordinary room temperatures.

Note 1???Test Method A (for heatset systems) specifies a specimen film thickness that is much thinner than those produced by related test methods; one exception is Test Method B in Test Methods D1259, which is recommended as a referee test.
Note 2???Test Method B (for liquid ink systems) is similar to Test Method D2369 except that a solvent is not required for spreading the test specimen.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 87.080
Nederlandse titel Standard Test Methods for Nonvolatile Content of Heatset and Liquid Printing Ink Systems
Engelse titel Standard Test Methods for Nonvolatile Content of Heatset and Liquid Printing Ink Systems

Winkelwagen

Subtotaal:

Ga naar winkelwagen