Norm

ASTM D4812-11

Standard Test Method for Unnotched Cantilever Beam Impact Resistance of Plastics

61,51

Over deze norm

Status Definitief
Aantal pagina's 12
Commissie D20.10
Gepubliceerd op 01-12-2011
Taal Engels

1.1 This test method covers the determination of the resistance of plastics to breakage by flexural shock, as indicated by the energy extracted from standardized pendulum-type hammers, mounted in standardized machines, in breaking standard specimens with one pendulum swing. The result of this test method is reported as energy absorbed per unit of specimen width.

Note 1—The pendulum-type test instruments have been standardized in that they must comply with certain requirements, including a fixed height of hammer fall that results in a substantially fixed velocity of the hammer at the moment of impact. Pendulums of different initial energies (produced by varying their effective weights) are recommended for use with specimens of different impact strengths. Moreover, manufacturers of the equipment are permitted to use different lengths and constructions of pendulums (with resulting possible differences in pendulum rigidities (see Section 5), and other differences in machine design).

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2—This standard and ISO 180, Method U address the same subject matter, but differ in technical content.

Details

ICS-code 83.140.99
Nederlandse titel Standard Test Method for Unnotched Cantilever Beam Impact Resistance of Plastics
Engelse titel Standard Test Method for Unnotched Cantilever Beam Impact Resistance of Plastics

Winkelwagen

Subtotaal:

Ga naar winkelwagen